DragonFly On-Line Manual Pages
ACPI_THERMAL(4) DragonFly Kernel Interfaces Manual ACPI_THERMAL(4)
acpi_thermal -- ACPI thermal management subsystem
The acpi_thermal driver provides the thermal management features of the
ACPI module. This driver has a sysctl(8) interface and a devd(8) notifi-
cation interface. The sysctls export properties of each ACPI thermal
There can be multiple thermal zones in a system. For example, each CPU
and the enclosure could all be separate thermal zones, each with its own
setpoints and cooling devices. Thermal zones are numbered sequentially
in the order they appear in the AML.
The acpi_thermal driver also activates the active cooling system accord-
ing to each thermal zone's setpoints.
Number of seconds to continue active cooling once started. A new
active cooling level will not be selected until this interval
Number of seconds between polling the current temperature. If
set to 0, temperature polling is deactivated. Use with care,
strange hardware-specific issues can occur when a wrong value is
set. Some systems will always report the same temperature when
the polling period is too low. Also ACPI based fan control can
stop working when the wrong value is set here.
If set to 1, allow user override of various setpoints (below).
The original values for these settings are obtained from the BIOS
and system overheating and possible damage could occur if
changed. Default is 0 (no override).
Current active cooling system state. If this is non-negative,
the appropriate _AC%d object is running. Set this value to the
desired active cooling level to force the corresponding fan
object to the appropriate level.
If set to 1, passive cooling is enabled. Default is enabled for
tz0 where it is available.
Current thermal zone status. These are bit-masked values.
Current temperature for this zone.
Temperature to start passive cooling by throttling down CPU, etc.
This value can be overridden by the user.
Temperature to start critical suspend to disk (S4). This value
can be overridden by the user.
Temperature to start critical shutdown (S5). This value can be
overridden by the user.
Temperatures at which to switch to the corresponding active cool-
ing level. The lower the _ACx value, the higher the cooling
All temperatures are printed in Celsius. Values can be set in Celsius
(by providing a trailing "C") or Kelvin (by leaving off any trailing let-
ter). When setting a value by sysctl(8), do not specify a trailing deci-
mal (i.e., 90C instead of 90.0C).
Notifies are passed to userland via devd(8). See /etc/devd.conf and
devd.conf(5) for examples. The acpi_thermal driver sends events with the
type The fully qualified thermal zone object path as in the ASL.
notify An integer designating the event:
0x80 Current temperature has changed.
0x81 One or more trip points (_ACx, _PSV) have changed.
0x82 One or more device lists (_ALx, _PSL, _TZD) have
0xcc Non-standard notify that the system will shutdown if
the temperature stays above _CRT or _HOT for one more
This manual page was written by Takanori Watanabe.
DragonFly 5.3 May 16, 2015 DragonFly 5.3