DragonFly On-Line Manual Pages

Search: Section:  

UTICOM(4)	      DragonFly Kernel Interfaces Manual	     UTICOM(4)


uticom -- Texas Instruments TUSB3410 RS232 to USB converter


To compile this driver into the kernel, place the following lines in your kernel configuration file: device uticom device ucom Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): uticom_load="YES"


The uticom driver supports virtual serial port functionality on devices based on Texas Instruments TUSB3410 serial to USB converter chip. Note that the driver doesn't support devices which have internal EEPROM with firmware. The device is accessed through the ucom(4) driver which makes it behave like a tty(4).


hw.usb.uticom.stickdsr If set to non-zero, DSR (Data Set Ready) signal from DCE is ignored and the TIOCM_DSR state flag is set unconditionally. It can be used if DSR signal from DCE is unreliable. Default is 0.


tty(4), ucom(4), usb(4)


The uticom device driver first appeared in DragonFly 1.11.


The uticom driver was written by Dmitry Komissaroff <dxi@mail.ru> and Hasso Tepper <hasso@estpak.ee>. DragonFly 4.1 November 11, 2007 DragonFly 4.1

Search: Section: