DragonFly On-Line Manual Pages
VKNET(1) DragonFly General Commands Manual VKNET(1)
vknet -- create a bridged network between two hosts over ssh(1)
vknet [-C] [-b local-bridge] [-B remote-bridge] [-r delay[:retries]]
vknet -S [-b local-bridge] local-spec
The vknet utility connects the local machine's network to the remote
machine's network over a SSH connection.
The local and remote specification typically supplies a path to a vknetd
socket such as /var/run/vknet, but may also specify a tap(4) interface or
the auto keyword to automatically allocate a tap(4) interface.
remote-spec defaults to /var/run/vknet.
If a TAP interface is used on any given side it can be bridged on that
If a unix domain socket path is specified vknet connects to use via the
SOCK_SEQPACKET socket type. vknetd(8) sockets cannot be bridged (but you
don't want to anyway because vknetd is already typically connected to a
potentially bridged TAP interface).
The following options are available:
-C Request that ssh(1) compress the connection.
Specify that the local specification, which must be a TAP interface
or auto, be bridged to the specified bridge.
Specify that the remote specification, which must be a TAP inter-
face or auto, be bridged to the specified bridge on the remote
If the link cannot be established or is lost, delay the specified
number of seconds and retry. If no retry limit is specified an
unlimited number of retries will be made.
-S This option is used by the vknet run on the remote side of the
ssh(1) link to use stdin and stdout as its remote specification.
This option is typically not specified manually.
You may have to load the if_tap and/or if_bridge modules, or run
vknetd(8) to provide an interconnect to the local and remote machine's
/dev/tap* TAP interface used to route packets from userland
providers back into the real machine. If not otherwise
specified an unused TAP interface will be selected.
/var/run/vknet Socket vknet typically connects to, established by
vknet -r 5 /var/run/vknet myhomesystem:/var/run/vknet
vknet -r 5 -b bridge0 -B bridge0 auto myhomesystem:auto
ssh(1), bridge(4), tap(4), vke(4), vkernel(7), vknetd(8)
The vknet command was written by Matthew Dillon and first appeared in
DragonFly 1.13 in May 2008.
There are currently no known bugs.
DragonFly 4.9 May 27, 2008 DragonFly 4.9