DragonFly users List (threaded) for 2007-02
DragonFly BSD
DragonFly users List (threaded) for 2007-02
[Date Prev][Date Next]  [Thread Prev][Thread Next]  [Date Index][Thread Index]

Re: Installing Dragonfly 1.8 hangs BIOS completly

From: "Rauf Kuliyev" <rauf@xxxxxxxxxxx>
Date: Mon, 19 Feb 2007 21:59:42 +0400


I bet it is IBM ThinkPad. You can find additional information here:


On 2/19/07, Michael Neumann <mneumann@ntecs.de> wrote:

Just a few minutes ago, I installed Dragonfly 1.8 onto my laptop.
Then I rebooted, and the BIOS hung up completely after showing that it
detected the harddisk and cdrom. I powered down and tried again, but
that didn't worked either. I couldn't even boot a CD or anything else or
couldn't even enter the BIOS setup.

The only thing that worked was to remove the harddisk physically and
then pluging it in a few seconds after the BIOS crossed the detection of
the devices. Using this method, I booted the Dragonfly installer cd and
used the disk tools to wipe out the beginning of the harddisk. Then I
rebooted again and voila, I could boot normally (without removing the
harddisk). Puh!

Now I tried a second time to install Dragonfly 1.8, but after I reboot
the BIOS hangs again!

I know that the BIOS should not hang up itself, but on the other hand
that didn't happen with any other operating system I installed on my
laptop (FreeBSD, NetBSD, DragonFly 1.6). So I think there is something
wrong in the 1.8 version. Any hints?



[Date Prev][Date Next]  [Thread Prev][Thread Next]  [Date Index][Thread Index]